Eaves Cantilever Systems

Our Lattice Roof Beam solutions can be designed to incorporate cantilever or 'oversail' eaves details.

The cantilever can be pre-engineered from either lightweight cold-rolled steel section or from hot-rolled joist section depending on loadings and cantilever length.

Beam Design Service

Eaves Cantilever Systems

Please click here for Steel Lattice Beam Literature »

Cantilever up to 1m
Cantilever up to 2m
Cantilever over 2m
  • Cantilever System up to 1m

    Top Chord Cantilever

    Top Chord Cantilever

    This detail can be used for small span cantilevers of up to 1m. Stiffener angles can be welded to the sides of the top chord of the steel beam, if required, to provide an economic cantilever solution.

    Beam Design Service

  • Cantilever System up to 2m

    cantilever-bolted-to-welded-stub-post Cantilever Bolted to Welded Stub-Post

    Cantilever Bolted to Welded Stub-Post

    This detail can be used for medium span cantilevers of up to 2m. The cantilever arm is bolted to the end post which is supplied welded into the end of the lattice steel truss. Since the cantilever roof element does not require an insulation layer the line of the supporting cantilever eaves structure is correspondingly raised to support the top sheet.

    Beam Design Service

  • Cantilever System over 2m

    Loose, Bolt-On Cantilever

    Loose, Bolt-On Cantilever

    This detail can be used for large span cantilevers of over 2m. The cantilever arm extends into the building to provide an adequate backing span and is bolted on to the top chord of the lattice steel truss.

    Beam Design Service